|
ELECTRIC |
|
Supply Voltage: |
1x200-240V +6%/-10%, 50/60 Hz, PE |
|
Operation Via Generator: |
1x100-115V +6%/-10%, 50/60 Hz, PE |
|
Starting Current: |
As
a minimum, the generator output must be equal the motor P1[kw] + 10% |
|
Starting: |
The motor starting current is equal to the highest stated on the motor
nameplate |
|
Run-up Time: |
Soft Start |
|
Motor Protection: |
Maximum: 2-seconds
Motor is protected against: Dry running, over voltage, under voltage,
overload, over temperature |
|
Power Factor: |
PF=1 |
|
Motor Cable: |
3
Wire, 14AWG XLPE |
|
Motor Liquid: |
Type SML 2 |
|
pH Values: |
SQ
and SQE: 5 to 9 |
|
Liquid Temperature: |
The temperature of the
pumped liquid must not exceed 104°F |
|
Note: If liquids with a viscosity higher than that of water are to be
pumped, please contact Grundfos |
|
PIPING CONNECTION |
|
Discharge Port:
|
5SQ/SQE - 1” NPT
10-15SQ/SQE - 1-1/4” NPT
22-30SQ/SQE - 1-1/2” NPT |
|
STORAGE CONDITIONS |
|
Frost Protection:
|
If
the pump has to be stored after use, it must be stored at a frost-free
location or it must be ensured that the motor liquid is frost proof. The
motor must be stored without being filled with motor liquid. |
|
OPERATING CONDITIONS |
|
Minimum Ambient Fluid Temperature: |
-
34°F |
|
Maximum Ambient Fluid Temperature: |
+140°F |
|
APPROXIMATE DIMENSIONS AND WEIGHT |
|
Motor Dimensions (MS 3 & MSE 3): |
|
|
0.33 - 0.50A [Hp] |
20.9” length x 2.68 diameter |
|
0.50 - 0.75B [Hp] |
20.9” length x 2.68 diameter |
|
1.0 - 1.5C [Hp] |
22.3” length x 2.68 diameter |
|
Motor Weights (MS3 & MSE3) |
|
|
0.33 - 0.50A [Hp] |
6.0 lbs |
|
0.50 - 0.75B [Hp] |
7.1 lbs |
|
1.0 - 1.5C [Hp] |
8.2 lbs |
|
Pump End Dimensions: |
|
|
Pump Diameter: |
2.68 |
|
Pump Diameter, incl cable guard |
2.91 |
|
Pump End Dimensions (min. and max.): |
|
5SQ/SQE |
10.6” to 18.0” |
|
10SQ/SQE |
10.6” to 16.9” |
|
15SQ/SQE |
10.6” to 16.9” |
|
22SQ/SQE |
10.6” to 13.7” |
|
Pump End Weights (min. and max.): |
|
|
All SQ/SQE Models |
2.2 lbs to 3.5 lbs |
|
Well Diameter: |
3-inch or larger |
|
Installation Depth (maximum) |
500 feet below static water level |
